Trying to get red/green/yellow/blue buttons to work

If you have a question or need help, this is the place to be.
Post Reply
bryanh99
Posts: 3
Joined: Fri Apr 12, 2019 7:42 pm

Trying to get red/green/yellow/blue buttons to work

Post by bryanh99 » Fri Apr 12, 2019 8:52 pm

All,

I have another question. I am setting up EG to work with an RF media remote (MemsArt MA144 is what Windows sees it as). I have almost everything working except I have a question. There are two HID entries for this remote and I have added both. But there is nothing logged for these buttons. Has anyone had this problem and is there a solution?

User avatar
kgschlosser
Site Admin
Posts: 4620
Joined: Fri Jun 05, 2015 5:43 am
Location: Rocky Mountains, Colorado USA

Re: Trying to get red/green/yellow/blue buttons to work

Post by kgschlosser » Sat Apr 13, 2019 3:09 am

I cannot find any information readily available on this remote control.

does this remote use the ehome drivers?
what plugin are you using to interface with the remote?


the same questions apply to your other post as well.
If you like the work I have been doing then feel free to Image

bryanh99
Posts: 3
Joined: Fri Apr 12, 2019 7:42 pm

Re: Trying to get red/green/yellow/blue buttons to work

Post by bryanh99 » Mon Apr 15, 2019 7:17 pm

Actually, after I posted this one I did a lot of further investigation. Seems those four buttons are IR programmable, so this question, sadly is moot.

Post Reply